Copy and Edit

wirelessQ1

Description

notes.
michael.0lsn
Quiz by michael.0lsn, updated more than 1 year ago
michael.0lsn
Created by michael.0lsn about 8 years ago
80
1
1

Resource summary

Question 1

Question
How many antennas are used with diversity?
Answer
  • FOUR
  • ONE
  • THREE
  • TWO

Question 2

Question
Which of the following measurements is referenced against an antenna that radiates perfectly in all directions?
Answer
  • dBi
  • dBm
  • dBd
  • dB

Question 3

Question
Bob works as a network administrator for ABC Auto Inc. The company deploys a wireless LAN network but there is some problem due to the interference of signals. Which of the following tools should you use to determine signal strength, noise level. (Choose two.)
Answer
  • SNR
  • dBm
  • RSSI
  • EIRP

Question 4

Question
A single 802.11 access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose three)
Answer
  • Null SSID
  • Metal file cabinets
  • Cordless phones
  • Antenna type or direction
  • Mismatched SSID

Question 5

Question
To display the coverage from the top of the antenna, what plane is represented?
Answer
  • Airplane
  • C-Plane
  • E-Plane
  • H-Plane

Question 6

Question
Metal desks, glass, light fixtures, and computer screens can contribute to which influence on wireless transmissions?
Answer
  • Absorption
  • Scattering
  • Reflection
  • Refraction

Question 7

Question
Which of the following statements is true about free space path loss?
Answer
  • RF signals will attenuate as they travel because of obstructions
  • Path loss occurs at a constant linear rate
  • Path loss primarily occurs because of cancellation
  • RF signals will attenuate as they travel despite the lack of attenuation caused by obstructions.

Question 8

Question
What does amplitude measure?
Answer
  • Distance from high crest to high crest horizontally in a waveform
  • Distance between two access points
  • Height of wave from lowest crest to highest crest
  • Distance from low crest to midspan in a waveform

Question 9

Question
Using knowledge of RF characteristics and behaviors, which two options should a WLAN engineer be most concerned about during an indoor site survey? (Choose two.)
Answer
  • User Density
  • Brick Wall
  • Indoor temperature
  • Dry wall

Question 10

Question
Bob works as a network administrator for the superawesomedelvery.com at Calgary. Bob was asked to implement WLAN in an office area. He deployed APs with internal antennas and mounted them on the wall. After Bob deployed APs, neighboring companies; specially, ones are a floor above and below have been complaining about interferences. What is likely caused the interferences?
Answer
  • Incorrect type of APs are used
  • Incorrect installation- APs should be mounted on the celling
  • Incorrect antennas used –should have used external antennas
  • Incorrrect type of cables and connectors are used

Question 11

Question
Which of the following are true about cables? (Choose two)
Answer
  • They work regardless of the frequency
  • Attenuation decreases as frequency increases
  • They add and loss to the signal
  • They cause impedance on the signal

Question 12

Question
Which of the following methods can be used to send more data across the airwaves?
Answer
  • Use more frequency
  • Utilize lower band frequencies
  • Utlize upper band frequencies
  • Use more complex encoding

Question 13

Question
If you have a wireless network that connects buildings for very long distances, and covers a large geographic area, what is this network called?
Answer
  • WWAN
  • WLAN
  • WMAN
  • WPAN

Question 14

Question
Which type of antenna produces the least amount of passive gain?
Answer
  • Omnidirectional
  • Semidirectional
  • Yagi
  • Parabolic Dish

Question 15

Question
To lower the amount of energy being sent to the antenna, which of the following device could be used?
Answer
  • Amplifier
  • Lightning arrestor
  • Fiber-patch
  • Attenuator

Question 16

Question
How much overlap is needed when an AP is a wireless repeater mode?
Answer
  • 10 to 15 percent
  • 40 to 80 percent
  • 50 percent
  • 100 percent

Question 17

Question
Which of the following statements is correct?
Answer
  • A lower-frequency signal travels less than a higher-frequency signal and attenuates faster.
  • A lower-frequency signal travels farther than a higher-frequency signal but attenuates faster
  • A higher-frequency signal travels less than a lower-frequency signal and attenuates faster
  • A higher-frequency signal travels farther than a lower-frequency signal but attenuates faster

Question 18

Question
Which of the following best describes a frequency that is seen 1 million times per second?
Answer
  • 1 Hz
  • 1 MHz
  • 1000000 Mb
  • 1 joule

Question 19

Question
EIRP is calculated using which of the following formulas?
Answer
  • EIRP = cable gain – cable loss + antenna gain
  • EIRP = interference – cable loss + antenna gain
  • EIRP = transmitter power – cable loss + antenna gain
  • EIRP = transmitter loss + cable loss + antenna gain

Question 20

Question
Select one that represents the strongest signal as measured in RSSI.
Answer
  • –75 dBm
  • –90 dBm
  • –60 dBm
  • –15 dBm

Question 21

Question
Which of the followings are types of polarization? (Choose all that apply.)
Answer
  • Horizontal
  • Vertical
  • Nautical
  • Circular

Question 22

Question
When the multiple RF signals arrive at a receiver at the same time and they are ____________ with the primary wave, the result can be _______________of the primary signal.
Answer
  • In phase, intersymbol interference
  • In phase, cancellation
  • 180 degrees, out of phase, cancellation
  • 180 degrees out of phase, amplification
  • Out of phase, scattering

Question 23

Question
What percentage of the Fresnel Zone must be clear of obstructions for a signal to be received properly?
Answer
  • 60%
  • 40%
  • 70%
  • 20%

Question 24

Question
Which of the following statements is true regarding bridged networks?
Answer
  • Root bridges can only communicate to APs.
  • Nonroot bridges can only communicate to root bridges.
  • Root bridges can only communicate to other root bridges
  • Nonroot bridges can only communicate to nonroot bridges

Question 25

Question
Choose two the main categories of antennas?
Answer
  • Omnidirectional
  • Yagi
  • Unidirectional
  • Directional

Question 26

Question
If an AP is not used in a wireless network, this is called which of the following?
Answer
  • BSS
  • Solitary Service Set
  • Single-Mode Set (SMS)
  • Independent Basic Service Set (IBSS)

Question 27

Question
You are designing a wireless network in a medical facility, which three areas are bad location to install a wireless access point?
Answer
  • Next to the electrical room
  • In the hallways
  • In the lobby
  • Near medical imaging devices
  • In front of the elevators doors
  • Inside offices
Show full summary Hide full summary

Want to create your own Quizzes for free with GoConqr? Learn more.

Similar

How does Harper Lee present Jem and Scout's changing relationship in To Kill A Mockingbird?
Keera
food
quintoprimariabo
Découvert de GoConqr
C-N TRAN
World War 2 In India
studyhani
The Independence Settlement
studyhani
notes
madeeasy ias
note
ReecePleaseWeight!
SPORTS
quintoprimariabo
maths notes
grace tassell
GoConqr Getting Started Guide
Norman McBrien
AS Biology- OCR- Module 1 Cells Specification Analysis and Notes
Laura Perry
Browse Library