Igneous Rocks and Rates of Cooling

Description

Undergraduate Geology - Part 2 (Igneous Processes and Products) Note on Igneous Rocks and Rates of Cooling, created by siobhan.quirk on 17/05/2013.
siobhan.quirk
Note by siobhan.quirk, updated more than 1 year ago
siobhan.quirk
Created by siobhan.quirk over 11 years ago
268
0

Resource summary

Page 1

Crystal Grain SizeExamining crystals in igneous rocks is one of the quickest ways to identify rocks in the field or from samples.The rate of cooling is the main factor that controls crystal size. The general rule is the slower the rate of cooling, the larger the crystal size.However, there are other factor that can be important. Where an intrusion is large, the inside of the intrusion will cool more slowly than the outer part. This is because it is better insulated and will lose heat more slowly.If a large intrusion cooled at a depth of 1km, it could have a range of crystal grain sizes from fine at the edges to coarse in the centre.Crystal Grain Size and Depth of CoolingGlassy No crystals Forms very quickly - in hours, usually in the sea as water is the quickest way of cooling magma At the surface - they are always volcanic extrusive Fine Crystals are <1mm so individual crystals cannot be seen by eye Forms due to rapid cooling over weeks or months At the surface in extrusive volcanic rocks as lava flows. In chilled margins at the edges of minor intrusions Medium 1-5mm in size, so individual crystals can be seen by eye but are difficult to identify fairly slow cooling - over a few thousand years Below the surface in minor intrusions - 1km down (hypabyssal) Coarse Crystals are >5mm, so can be seen and identified in hand specimens Cools very slowly over millions of years Found in major intrusions at great depth >10km down as batholiths or plutonic rocks Glassy TextureIf lava flows into the sea, cooling can be very rapid - in minutes on the outside of the flow. The inside could still be molten. This is why some pillow lavas show a layered structure with glass on the outside and fine crystals inside. Where cooling is rapid, there may be no time for crystals to form. Obsidian forms in this way. It looks black because light will not pass through it, but in thin section is clear glass.PegmatitesA pegmatite is an igneous rock that has exceptionally large crystals. The crystals are normally larger than a few centimetres and can be often tens of centimetres or even metres long. Pegmatites form in the last stages of crystallisation from the water-rich residual magma. The pegmatite crystals of quartz, K feldspar and muscovite grow in a supersaturated solution. Pegmatites can produce large crystals in a short period of time.

New Page

Show full summary Hide full summary

Similar

Differences Between Intrusive and Extrusive Rocks
siobhan.quirk
The Results of Magmatic Differentiation
siobhan.quirk
Igneous Rocks
siobhan.quirk
Identifying Silicic and Intermediate Igneous Rocks
siobhan.quirk
Volcanic Eruptions of Mafic Magma
siobhan.quirk
Living with Volcanic Activity
siobhan.quirk
Predicting Volcanic Eruptions
siobhan.quirk
Differentiation of Magma
siobhan.quirk
Products of Volcanoes
siobhan.quirk
Where to find the pyroclasts
siobhan.quirk
Igneous Textures
siobhan.quirk