3. Performance

Description

Tema 1 Performances Quiz on 3. Performance, created by Jose Antonio Vazquez on 06/11/2018.
Jose Antonio Vazquez
Quiz by Jose Antonio Vazquez, updated more than 1 year ago
Jose Antonio Vazquez
Created by Jose Antonio Vazquez about 6 years ago
510
3

Resource summary

Question 1

Question
119) In the drag versus TAS curve for a jet aeroplane, the speed for maximum range corresponds with:
Answer
  • the point of contact of the tangent from the origin to the drag curve.
  • the point of intersection of the parasite drag curve and the induced drag curve.
  • the point of contact of the tangent from the origin to the parasite drag curve.
  • the point of contact of the tangent from the origin to the induced drag curve.

Question 2

Question
145) If the antiskid system is inoperative, which of the following statements is true?
Answer
  • It has no effect on the accelerate stop distance.
  • Take-off with antiskid inoperative is not permitted.
  • The accelerate stop distance increases.
  • The accelerate stop distance decreases.

Question 3

Question
146) A runway is contaminated with 0.5 cm of wet snow. The flight manual of a light twin nevertheless authorises a landing in these conditions. The landing distance will be, in relation to that for a dry runway:
Answer
  • reduced
  • substantially decreased
  • increased
  • unchanged

Question 4

Question
147) Which of the following represents the maximum value for V1 assuming max tyre speed and max brake energy speed are not limiting?
Answer
  • VREF
  • VR
  • VMCA
  • V2

Question 5

Question
148) The lowest take-off safety speed (V2 min) is:
Answer
  • 1.15 Vs for all turbojet aeroplanes.
  • 1.20 Vs for all turboprop powered aeroplanes.
  • 1.15 Vs for four-engine turboprop aeroplanes and 1.20 Vs for two or three-engine turboprop aeroplanes.
  • 1.20 Vs for all turbojet aeroplanes.

Question 6

Question
149) A 'Balanced Field Length' is said to exist where:
Answer
  • The accelerate stop distance is equal to the take-off distance available.
  • The clearway does not equal the stopway.
  • The accelerate stop distance is equal to the all engine take-off distance.
  • The one engine out take-off distance is equal to the all engine take-off distance.

Question 7

Question
151) Complete the following statement regarding the take-off performance of an aeroplane in performance class A. Following an engine failure at (i) ........... and allowing for a reaction time of (ii) ........... a correctly loaded aircraft must be capable of decelerating to a halt within the (iii) .........
Answer
  • (i) V1 (ii) 2 seconds (iii) Accelerate - stop distance available.
  • (i) V2 (ii) 3 seconds (iii) Take-off distance available.
  • (i) V1 (ii) 1 second (iii) Accelerate - stop distance available.
  • (i) V1 (ii) 2 seconds (iii) Take-off distance available.

Question 8

Question
154) The speed V2 is
Answer
  • that speed at which the PIC should decide to continue or not the take-off in the case of an engine failure.
  • the lowest airspeed required to retract flaps without stall problems.
  • the lowest safety airspeed at which the aeroplane is under control with aerodynamic surfaces in the case of an engine failure.
  • the take-off safety speed.

Question 9

Question
142) The speed VS is defined as
Answer
  • speed for best specific range.
  • stalling speed or minimum steady flight speed at which the aeroplane is controllable.
  • safety speed for take-off in case of a contaminated runway.
  • design stress speed.

Question 10

Question
156) A higher outside air temperature
Answer
  • does not have any noticeable effect on climb performance.
  • reduces the angle of climb but increases the rate of climb.
  • reduces the angle and the rate of climb.
  • increases the angle of climb but decreases the rate of climb.

Question 11

Question
157) During the flight preparation a pilot makes a mistake by selecting a V1 greater than that required. Which problem will occur when the engine fails at a speed immediatly above the correct value of V1?
Answer
  • The stop distance required will exceed the stop distance available.
  • The one engine out take-off distance required may exceed the take-off distance available.
  • V2 may be too high so that climb performance decreases.
  • It may lead to over-rotation.

Question 12

Question
158) What is the effect of a head wind component, compared to still air, on the maximum range speed (IAS) and the speed for maximum climb angle respectively?
Answer
  • Maximum range speed decreases and maximum climb angle speed decreases.
  • Maximum range speed increases and maximum climb angle speed increases.
  • Maximum range speed increases and maximum climb angle speed stays constant.
  • Maximum range speed decreases and maximum climb angle speed increases.

Question 13

Question
160) The lift coefficient decreases during a glide with constant Mach number, mainly because the :
Answer
  • TAS decreases.
  • glide angle increases.
  • IAS increases.
  • aircraft mass decreases.

Question 14

Question
161) The speed V2 of a jet aeroplane must be greater than:
Answer
  • 1.2VMCG.
  • 1.05VLOF.
  • 1.3V1.
  • 1.2Vs.

Question 15

Question
162) When an aircraft takes off with the mass limited by the TODA:
Answer
  • the actual take-off mass equals the field length limited take-off mass.
  • the distance from brake release to V1 will be equal to the distance from V1 to the 35 feet point.
  • the "balanced take-off distance" equals 115% of the "all engine take-off distance".
  • the end of the runway will be cleared by 35 feet following an engine failure at V1.

Question 16

Question
163) A runway is contaminated by a 0,5 cm layer of wet snow. The take-off is nevertheless authorized by a light-twin's flight manual. The take-off distance in relation to a dry runway will be:
Answer
  • very significantly decreased
  • increased
  • unchanged
  • decreased

Question 17

Question
349) A jet aeroplane is flying long range cruise. How does the specific range / fuel flow change?
Answer
  • Decrease / decrease.
  • Increase / decrease.
  • Increase / increase.
  • Decrease / increase.

Question 18

Question
153) Which of the following combinations basically has an effect on the angle of descent in a glide? (Ignore compressibility effects.)
Answer
  • Configuration and mass.
  • Configuration and angle of attack.
  • Mass and altitude.
  • Altitude and configuration.

Question 19

Question
132) Which of the following sets of factors will increase the climb-limited TOM?
Answer
  • High flap setting, low PA, low OAT.
  • Low flap setting, high PA, high OAT.
  • Low flap setting, high PA, low OAT.
  • Low flap setting, low PA, low OAT.

Question 20

Question
122) The absolute ceiling
Answer
  • is the altitude at which the best climb gradient attainable is 5%
  • is the altitude at which the aeroplane reaches a maximum rate of climb of 100 ft/min.
  • is the altitude at which the rate of climb theoretically is zero.
  • can be reached only with minimim steady flight speed

Question 21

Question
123) The maximum indicated air speed of a piston engined aeroplane, in level flight, is reached:
Answer
  • at the service ceiling.
  • at the practical ceiling.
  • at the lowest possible altitude.
  • at the optimum cruise altitude.
Show full summary Hide full summary

Similar

2.1AVIOìN Y MOTOR 235 SEP09 CON RESPUESTAS (REPASAR)
Jose Antonio Vazquez
6. Performance
Jose Antonio Vazquez
EXAM TIME FICHAS
Daniela Velasque5264
Importancia de una Edificación
Ricardo Avendaño
FUENTES DE ENERGÍA
Alba Guzman
ACCIONES PARA CONVIVIR EN MEDIO DE LAS DIFERENCIAS
flaviotejada2003