Brian Gamble
Quiz by , created more than 1 year ago

CCNA ICND2 (Chapter 10) Quiz on ICND2 Ch 10 quiz, created by Brian Gamble on 03/02/2016.

4
0
0
Brian Gamble
Created by Brian Gamble over 8 years ago
Close

ICND2 Ch 10 quiz

ICND2 Ch 10 quiz

Question 1 of 8

1

A classful network in which packets sent between at least one pair of subnets must pass through subnets of a different classful network.

Select one of the following:

  • Contiguous

  • Discontiguous

Explanation

Question 2 of 8

1

A classful network in which packets sent between every pair of subnets can pass only through subnets of that same classful network, without having to pass through subnets of any other classful network.

Select one of the following:

  • Contiguous

  • Discontiguous

Explanation

Question 3 of 8

1

What is Step 2 for EIGRP configuration?

Select one of the following:

  • Impact metric calculations by tuning bandwidth and delay using the bandwidth value and delay value interface subcommand.

  • Set the EIGRP router ID (RID) explicitly with the eigrp router-id value router subcommand

  • Enter configuration mode and define the EIGRP autonomous system number (ASN) by using the router eigrp as-number global command.

  • Configure one or more network ip-address [wildcard-mask] router subcommands. This enables the EIGRP on any matched interface and causes EIGRP to advertise the connected subnet.

Explanation

Question 4 of 8

1

Routes that are neither successor nor FS can never be added to the IP routing table regardless of the varianc e setting, because doing so may cause packets to loop.

Select one of the following:

  • True
  • False

Explanation

Question 5 of 8

1

R2 has two routes to network 10.0.0.0/8: one pointing left toward R1 and one pointing right toward R3. R2 simply uses its usual load-balancing logic, because as far as R2 can tell the two routes are simply equal-cost routes to the same destination: the entire network 10.0.0.0. Sometimes R2 happens to forward a packet toward the correct destination, and sometimes not. This problem has two solutions; what are they?

Select one or more of the following:

  • Create IP addressing plans that do not create discontiguous classful networks

  • Use autosummary by using EIGRP defaults

  • Create IP addressing plans that create discontiguous classful
    networks

  • Do not use autosummary by using EIGRP defaults

Explanation

Question 6 of 8

1

The only difference compared to OSPF is that the EIGRP RID is configured with the __________________ router subcommand, whereas OSPF uses the router-id value subcommand.

Select one of the following:

  • Router eigrp

  • Eigrp router-id value

  • Show ip route eigrp

  • none of these

Explanation

Question 7 of 8

1

What is the report distance (RD)?

Select one of the following:

  • What is the report distance (RD)?

  • The metric of the best route to reach a subnet

  • The result of the calculation of the EIGRP metric for a route

  • The metric calculated from the perspective of the next-hop router

Explanation

Question 8 of 8

1

In real networks, most people prefer to use autosummary today

Select one of the following:

  • True
  • False

Explanation

Previous
Next