Certainteed Self-Test Section 5

Quiz by Connor Sheffield , created more than 1 year ago

Sales Representative Roofing (Self-Test ) Quiz on Certainteed Self-Test Section 5, created by Connor Sheffield on 20/11/2019.

	Created by Connor Sheffield about 5 years ago

Sales Representative Roofing (Self-Test ) Quiz on Certainteed Self-Test Section 5, created by Connor Sheffield on 20/11/2019.

Certainteed Self-Test Section 5

Question 1 of 13

Roofer’ Select shingle underlayment the ASTM D6757 standard and has more resistance to tearing and wrinkling than #15 type underlayment.

Select one of the following:

Explanation

Question 2 of 13

Typically, when installing water-resistant underlayment, side laps should be at least two inches and end laps at least six inches

Select one of the following:

Explanation

Question 3 of 13

One reason to use water resistant underlayment is that is part of Class A fire-rated shingle systems.

Select one of the following:

Explanation

Question 4 of 13

Joint overlaps for DiamondDeck are different than felt and vary by roof slope.

Select one of the following:

Explanation

Question 5 of 13

WinterGuard HT has more aggressive “tack” than granular or sand-surfaced WinterGuard and can be installed under asphalt shingles tile or metal roofs.

Select one of the following:

Explanation

Question 6 of 13

Metalayment is a film-surfaced product that meets ASTM D1970 and can only be applied under metal roofs.

Select one of the following:

Explanation

Question 7 of 13

All shingles applied to a low slope deck require the use of WinterGuard or its equivalent applied over the entire deck.

Select one of the following:

Explanation

Question 8 of 13

WinterGuard can be installed over the fascia board to protect against ice build-up in gutters.

Select one of the following:

Explanation

Question 9 of 13

Drip edge may be applied either over or under WinterGuard along the rake.

Select one of the following:

Explanation

Question 10 of 13

At the eaves, if there is a chance of snow or ice build-up in the gutters, never install drip edge under the WinterGuard.

Select one of the following:

Explanation

Question 11 of 13

WinterGuard can be applied when the temperature falls below 40 Degrees Fahrenheit.

Select one of the following:

Explanation

Question 12 of 13

For ice dam protection, WinterGuard must be applied along the eaves and up the roof no less the 24” beyond the interior wall line.

Select one of the following:

Explanation

Question 13 of 13

When applying Flintlastic SA, you have the option of installing either a 2-ply or 3-ply roof system.

Select one of the following:

Explanation